Introduction to MultiSIM-week 1 lab

Complete Lab1 — Introduction to MultiSIM”

1. Open the file entitled “Lab1.ms11” Lab1.ms11
2. Run simulation and take a screen capture of the measurements
3. Paste screen capture into a Word document
4. Create a new file called “Lab1_Revised_StudentID.ms11” with your student id substituted into the file name.
5. Change the voltage source, R1 and R2 that were part of “Lab1.ms11” to the following:
   1. V1 = 10V
   2. R1 = 100kohm
   3. R2 = 100kohm
6. Include a voltmeter to measure voltage across R1 and R2
7. Run simulation and take a screen capture of the measurements
8. Paste screen capture into a Word document
9. Save the Word document for upload entitled: “Lab1_Revised_StudentID”
10. Include the following in the file for upload:
11. Section I: Lab1